KROHNE OPTIFLEX 8200 C Handbook page 88

OPERATION
6
Menu Function
No.
1.4.0 Application Setup 1.4.0 Application Setup 1.4.0 Application Setup 1.4.0 Application Setup
Use this quick set-up procedure to give the settings about the application type and the dielectric constant of
the top product.
Application Type
Epsilon R
Product
1.5.0 Options 1.5.0 Options
1.5.0 Options 1.5.0 Options
Options can be included in the customer order or you can buy this option after delivery. For more data, speak
or write to your supplier.
1.5.1 Interface Capab.
1.5.2 Gas Phase Comp.
1.6.0 Maintenance Setup 1.6.0 Maintenance Setup 1.6.0 Maintenance Setup 1.6.0 Maintenance Setup
1.6.1 Converter Type
Converter
Version
Remote Cable
Length
88
Function description
This function tells the device what to look
for in the tank and what to do with the
measurement signals.
If the device has the Dynamic Gas-phase Dynamic Gas-phase Dynamic Gas-phase Dynamic Gas-phase
Compensation Compensation (DGC) option, the device will
Compensation Compensation
do a process analysis to measure the
dielectric constant of the gas above the
product in the tank.
This is the dielectric constant of the top
product.
If Epsilon R Product Epsilon R Product Epsilon R Product is "Known", give the Epsilon R Product
correct value for the dielectric constant.
If Epsilon R Product Epsilon R Product is "Unknown". Epsilon R Product Epsilon R Product
What is the product family?
A device option. This function shows if the
Interface Capability mode is set to on (the Interface Capability
Interface Capability Interface Capability
menu item shows the message "option is
active").
You can set the Interface Capability Interface Capability Interface Capability mode Interface Capability
to on if you enter a code in this menu item.
If you do not have this code, contact your
supplier to buy this option.
A device option. This function shows if the
Dynamic Gas-phase compensation Dynamic Gas-phase compensation (DGC)
Dynamic Gas-phase compensation Dynamic Gas-phase compensation
mode is set to on (the menu item shows
the message "option is active").
You can set the DGC mode to on if you
enter a code in this menu item. If you do
not have this code, contact your supplier to
buy this option.
The signal converter is available in 3
versions. Make a selection from the list. If
you set Converter Type Converter Type to "S: REMOTE
Converter Type Converter Type
SENSOR", then you must also enter the
remote cable length.
The length of the sensor extension. If the
device is the sensor extension with
compact version (S), this is the coaxial
cable between the converter and the
process connection.
www.krohne.com
OPTIFLEX 8200 C/F/S
Selection list or range
of values
LEVEL, LEVEL +
INTERFACE MIXED,
LEVEL + INTERFACE
UNMIXED, INTERFACE
(FULLY SUBMERGED
PROBE), LEVEL WITH
GAS PHASE
COMPENSATION
5
Known, Unknown
min-max: 1....115
ACIDS, ALCOHOL, BASE,
HYDROCARBON,
LIQUID GAS,
MINERAL OIL, SOLVENT,
WATER-BASED, OTHER
C: COMPACT,
F: REMOTE CONVERTER
S: REMOTE SENSOR,
0...15 m
06/2018 - 4006448901 - MA OPTIFLEX 8200 R01 en
Default
LEVEL
67.5
OTHER
3
3