OPTIFLEX 8200 C/F/S
Equipment needed:
• Small slotted tip screwdriver (not supplied)
Procedure:
1 Put the terminal compartment cover adjacent to the housing.
2 Remove the connectors from the circuit board. If the device has the optional switch output,
remove the connector for the switch output.
3 Put the electrical cables in the cable entries. Connect the electrical wires to the connectors.
If the device has the optional switch output, use a 4-wire electrical cable for the switch power
supply connector and the output connector.
4 Attach the connectors to the circuit board. Tighten the cable entry glands.
Close the terminal compartment cover (one output)
Figure 4-8: How to close the terminal compartment cover (one output)
• Put the cover on the housing and push it down.
• Turn the cover clockwise until it is fully engaged.
• Tighten the lock screw.
Close the terminal compartment cover (two outputs)
Figure 4-9: How to close the terminal compartment cover (two outputs)
• Put the cover on the housing and push it down.
• Turn the cover clockwise until it is fully engaged.
• Tighten the lock screw.
06/2018 - 4006448901 - MA OPTIFLEX 8200 R01 en
ELECTRICAL CONNECTIONS
www.krohne.com
4
53