Table of Contents
Advertisement
ELECTRICAL CONNECTIONS
4
Figure 4-6: Procedure for electrical installation (one output)
Equipment needed:
• Small slotted tip screwdriver (not supplied)
Procedure:
1 Do not disconnect the safety cord from the terminal compartment cover. Put the terminal
compartment cover adjacent to the housing.
2 Remove the connector from the circuit board.
3 Connect the electrical wires to the connector.
4 Attach the connector to the circuit board. Tighten the cable entry glands.
Figure 4-7: Procedure for electrical installation (two outputs)
52
www.krohne.com
OPTIFLEX 8200 C/F/S
06/2018 - 4006448901 - MA OPTIFLEX 8200 R01 en
Advertisement
Table of Contents
