Table of Contents
Advertisement
OPTIFLEX 8200 C/F/S
Figure 3-28: Installation of the weather protection on a horizontal signal converter
INFORMATION!
Install the weather protection after you connect the device to the power supply.
1 Put the weather protection clamp around the front of the device (the end of the device that is
nearest to the cable entry).
2 Attach the two locking nuts to the threads on the weather protection clamp. Tighten the lock-
ing nuts with a 10 mm socket wrench.
3 Lower the weather protection cover onto weather protection clamp until the hole for the lock
is in the slot at the front of the cover.
4 Put the R-clip into the hole at the front of the weather protection cover.
i
End of the procedure.
The overall dimensions of the weather protection are on page 164.
06/2018 - 4006448901 - MA OPTIFLEX 8200 R01 en
www.krohne.com
INSTALLATION
3
45
Advertisement
Table of Contents
