Table of Contents
Advertisement
OPTIFLEX 8200 C/F/S
Part2: How to attach the locking nut and union nut
Figure 3-14: Part2: How to attach the locking nut and union nut
1 Attach a locking nut to the threaded rod below the process connection.
2 Make sure that the nut is fully engaged on the thread.
3 Attach the union nut to the threaded rod below the process connection.
4 Tighten these nuts with the two 8 mm open-ended wrenches.
5 Continue the assembly procedure on the page that follows.
06/2018 - 4006448901 - MA OPTIFLEX 8200 R01 en
www.krohne.com
INSTALLATION
3
33
Advertisement
Table of Contents
