KROHNE OPTIFLEX 8200 C Handbook page 107

OPTIFLEX 8200 C/F/S
• 2.3.2 Blocking Distance
An output agrees with ullage volume (empty volume) measurement when the output
function is set to "Distance conv." or "Interface dist. conv.". Menu items related to
ullage volume measurement are:
• 1.3.1 Output 1 Setup and 2.4.1 Output Function I1 (output 1)
• 1.3.2 Output 1 Setup and 2.4.7 Output Function I2 (optional output 2)
• 2.3.1 Tank Height
• 2.3.2 Blocking Distance
The device will give more accurate volume readings if you give more conversion data in these
areas:
• Surfaces with curves.
• Sudden changes in the cross section.
Refer also to the illustration that follows:
Figure 6-8: A plot of points for a volume or mass table
1 Tank with reference points
2 Tank model with plotted points
How to change values in a strapping table (conversion table)
• After you enter the 1.0.0 Advanced Setup
Conversion Setup procedure. Conversion Setup
Conversion Setup Conversion Setup
• Push 2 × [^ ^ ^ ^ ] to go to the conversion table.
• Push [ ] and [ ] to find the correct point in the table.
• Push [> > > > ]. The cursor moves to the length value. Push [> > > > ] to change the position of the cursor
and then push [ ] and [ ] to change the value of each digit. Push [^ ^ ^ ^ ] to go to the next step.
06/2018 - 4006448901 - MA OPTIFLEX 8200 R01 en
1.0.0 Advanced Setup menu, push [ ] and [> > > > ] to start to the 1.2.0
1.0.0 Advanced Setup 1.0.0 Advanced Setup
www.krohne.com
OPERATION
6
1.2.0
1.2.0 1.2.0
107