KROHNE OPTIFLEX 8200 C Handbook page 214

APPENDIX
10
Figure 10-4: Types of emulsion
1 Constant-mix emulsion
2 Gradually mixed emulsion
3 Interface distance
4 Oil
5 Water
6 Emulsion (constant mix, >5% of water)
7 Emulsion (gradually mixes with water)
I
Interface Interface Interface Interface
Interface distance Interface distance
Interface distance Interface distance
Interface level Interface level Interface level Interface level
L
Layer Layer
Layer Layer
Level Level
Level Level
M
Mass Mass Mass Mass
Measurement pulse Measurement pulse
Measurement pulse Measurement pulse
214
A surface where two liquids meet.
This is a display option. It is the distance from the face of the flange to the
interface. See the diagram at the end of this section.
This is a display option. It is the height from the bottom of the tank (user-
defined) to the interface (or tank height - interface distance). Refer to the
diagrams at the end of this section.
This is a display option. It gives the thickness of top product. The layer must
be more than 50 mm or 2¨ for accurate measurement of level and/or
interface. Refer to the diagrams at the end of this section.
This is a display option. It is the height from the bottom of the tank (user-
defined) to the surface of the top product (Tank height – distance). Refer to
the diagrams at the end of this section.
This is a display option. It shows the total mass of tank contents. Use a
mass table or a volume table to display measurement data with mass
units.
The device transmits a short, low-powered electrical pulse or wave
transmitted down a guide to the process. The process (or the probe end if
in TBF measurement mode) reflects the pulse back to the device.
www.krohne.com
OPTIFLEX 8200 C/F/S
06/2018 - 4006448901 - MA OPTIFLEX 8200 R01 en