KROHNE OPTIFLEX 8200 C Handbook page 84

OPERATION
6
Advanced Setup
The Advanced Setup menu is a list of procedures that have more functions than the Auto Setup
procedure.
Push the [> > > > ] to go to Configuration mode. Enter the Supervisor password.
Menu Function
No.
1.0.0 Advanced Setup
1.1.0 Installation Setup 1.1.0 Installation Setup
1.1.0 Installation Setup 1.1.0 Installation Setup
This starts a quick setup procedure to give the device data about the tank. This data includes installation type
and tank height. If the device is installed in stilling well or a bypass chamber, give the height and the internal
diameter of the chamber.
Installation Type
Tank Height
Stilling Well
Height
Internal Diameter The internal diameter of the stilling well or
1.2.0 Conversion Setup 1.2.0 Conversion Setup 1.2.0 Conversion Setup 1.2.0 Conversion Setup
Use this quick setup procedure to make a conversion table (strapping table) to measure volume or mass.
The device uses a conversion table (strapping table) to convert measurements to volume and mass readings.
The readings are shown in normal mode. Go to this menu item and give the length unit and then the
conversion unit. Push the [> > > > ] button to enter the first level-conversion values. Then [> > > > ] again to enter the next
point. Continue the procedure until the device has data for all the entries. For more data, refer to
configure the device to measure volume or mass
84
Function description
The conditions in which the device is used.
If the device is installed on a tank, set this
step to "TANK". If the device is installed in
a stilling well or bypass chamber, set this
step to "STILLING WELL / BYPASS".
The distance from the tank connecting
flange face / thread stop down to the tank
bottom.
If Installation Type Installation Type is set to "STILLING
Installation Type Installation Type
WELL / BYPASS", Tank Height Tank Height Tank Height is replaced Tank Height
by two steps: Stilling Well Height Stilling Well Height and Stilling Well Height Stilling Well Height
Internal Diameter. Internal Diameter
Internal Diameter Internal Diameter
The distance from the tank connecting
flange face / thread stop down to the
bottom of the stilling well or the bottom
process connection of the bypass
chamber. This function replaces Tank
Height Height. It is available if Installation Type Installation Type is
Height Height Installation Type Installation Type
set to "STILLING WELL / BYPASS".
bypass chamber. It is available if
Installation Type Installation Type is set to "STILLING
Installation Type Installation Type
WELL / BYPASS".
www.krohne.com
Selection list or range
of values
TANK, STILLING WELL /
BYPASS
min-max:
0.0...99999 mm
min-max:
0.0...99999 mm
Tank Tank Tank
min-max: 40...1000 mm
on page 105.
06/2018 - 4006448901 - MA OPTIFLEX 8200 R01 en
OPTIFLEX 8200 C/F/S
Default
TANK
25000 mm
25000 mm
200 mm
How to