Table of Contents
Advertisement
INSTALLATION
3
Part 1: How to assemble the segmented single rod probe
Figure 3-17: Part 1: How to assemble the segmented single rod probe
CAUTION!
Make sure that the nuts are tight and the rod probe cannot loosen.
1 Attach a lock nut to the threaded rod below the process connection. Make sure that the nut is
fully engaged on the thread.
2 Attach a union nut to the threaded rod below the process connection.
3 Use two 8 mm open-end wrenches to tighten the union nut against the lock nut.
36
www.krohne.com
OPTIFLEX 8200 C/F/S
06/2018 - 4006448901 - MA OPTIFLEX 8200 R01 en
Advertisement
Table of Contents
