Lower Guide And Fold Roller Gap Adjustment - Horizon Fitness PF-P330 Manual

3: Adjusting and Checking Procedures
3-3

Lower Guide and Fold Roller Gap Adjustment

The shape of the lower guide is easy to be
deformed as shown in Fig.1.
Sheet goes to the fold roller after passing
through between the upper guide and
lower guide as shown in Fig.3.
The gap between the lower guide and the
first fold roller should be 1 mm (0.04".)
Check the gap.
- Looking from the infeed entrance, use a small light
and check if the three gaps between the lower
guide and fold roller are 1 mm (0.04" .) (Fig.2)
[Note]
Use a 1 mm-thick strip of sheet to check the
gap accurately.
- If the gap is not correct, go to the next step
Open the feed section cover. (Fig.4)
Remove the feed roller cover. (Fig.4)
- The lower guide positions under the upper guide.
Adjust the front edge of the lower guide to adjust
the gap.
These fronts align, and there is
1 mm (0.04") gap between the
lower guide and the fold roller.
Fig. 1 Lower Guide and First Fold Roller
.
The First Fold Roller
Lower Guide
Fig. 3 Upper and Lower Guides
The First Fold Roller
Lower Guide
Upper Gudie
Sheet
Feed Section
Cover
Fig. 2 Amount of the Gap
Feed Roller
Cover
Fig. 4 Feed Section Covers
3-4