• The CE can service the machine and turn the machine off and on. It is not necessary to ask the
Administrator to log in again each time the machine is turned on.
2. Go into the SP mode and set SP5169 to "1" if you must use the printer bit switches.
3. After machine servicing is completed:
• Change SP5169 from "1" to "0".
• Turn the machine off and on. Tell the administrator that you have completed servicing the
machine.
• The Administrator will then set the "Service Mode Lock" to ON.
Remarks
Display on the Control Panel Screen
The maximum number of characters which can show on the control panel screen is limited to 30
characters. For this reason, some of the SP modes shown on the screen need to be abbreviated. The
following are abbreviations used for the SP modes for which the full description is over 20 characters.
Paper Weight
2,
Thin paper: 52-59 g/m
Plain Paper: 60-81 g/m
Middle Thick: 82-105 g/m
Thick Paper 1: 106-169 g/m
Thick Paper 2: 170-220 g/m
Thick Paper 3: 221-256 g/m
2
Thick 4: 257 g/m
-300 g/m
Paper Type
N: Normal paper
MTH: Middle thick paper
TH: Thick paper
13.9-15.7lb.
2
, 16-21.6lb.
2
, 21.9-28lb.
2
, 28.5-44.9lb.
2
, 45-58lb.
2,
59-68lb
2
, 68.4-79.8lb
Paper Feed Station
P: Paper tray
B: By-pass table
Service Program Mode
379