Ricoh D143 Field Service Manual page 562

5. System Maintenance
5193 [External Controller Info. Settings]
001 -
5199 [Paper Exit After Staple End.]
001 -
Enables or disables the paper feeding out from the finisher without stapling.
• If this setting is "1: ON", paper is fed out without stapling at the maximum number of
the finisher stapling when the machine gets a multiple printing job (over maximum
number).
• If this setting is "0: OFF", paper is fed out with stapling at the maximum number of the
finisher stapling when the machine gets a multiple printing job (over maximum
number).
5212 [Page Numbering]
This program adjusts the position of the second side page numbers.
A "– value" moves the page number positions to the left edge. A "+ value" moves the page
number positions to the right edge.
Duplex Printout Right/Left
003
Position
Duplex Printout High/Low
004
Position
560
Sets the external controller type. This setting is
appropriately adjusted if an external controller is installed
in the machine.
[0 to 10 / 0 / 1/step]
0: No external controller installed
-
1: EFI controller
2: Ratio controller
3: Egret controller
4 to 10: Reserved
[ 0 or 1 / 0 / -]
*CTL
0: OFF, 1: ON
*CTL
[–10 to 10 / 0 / 1 mm/step]
[–10 to 10 / 0 / 1 mm/step]