Error Messages - Ricoh D143 Field Service Manual

9. The "Update is Done" message appears on the operation panel after completing the updating. The
message differs depending on the firmware that has been updated.
10. Switch the copier main power switch off when you see the "Update is Done" message or follow the
procedure that is displayed on the operation panel.
11. Press in the SD card to release it. Then remove it from the slot.
12. Switch the copier on for normal operation.

Error Messages

An error message shows in the first line if an error occurs during the download.
The error code consists of the letter "E" and a number. The example above shows error "E24" displayed.
For details, refer to the Error Message Table. (
Firmware Update Error
If a firmware update error occurs, this means the update was cancelled during the update because the
module selected for update was not on the SD card.
Recovery after Power Loss
If the ROM update is interrupted as a result of accidental loss of power while the firmware is updating,
then the correct operation of the machine cannot be guaranteed after the machine is switched on again.
If the ROM update does not complete successfully for any reason, then in order to ensure the correct
operation of the machine, the ROM update error will continue to show until the ROM is updated
successfully.
In this case, insert the card again and switch on the machine to continue the firmware download
automatically from the card without the menu display.
"p.751" in this section)
Firmware Update
747