Ricoh D143 Field Service Manual page 507

Repeat Number: Non-use
Specifies the maximum number of repeats of the toner density adjustment in stand by
mode.
0: Disabled, 1 to 3: Repeat number,
003
4: Repeat three times (No consumption mode)
5: Repeat three times (Toner is supplied only when the toner density is too low, and toner is
consumed only when the toner density is too dark.)
6 to 9: Disabled
Repeat Number: ACC
Specifies the maximum number of repeats of the toner density adjustment at ACC.
0: Disabled, 1 to 3: Repeat number,
004
4: Repeat three times (No consumption mode)
5: Repeat three times (Toner is supplied only when the toner density is too low, and toner is
consumed only when the toner density is too dark.)
6 to 9: Disabled
Repeat Number: Recovery
005
Not used
Repeat Number: Job End
Specifies the maximum number of repeats of the toner density adjustment at job end.
0: Disabled, 1 to 3: Repeat number,
006
4: Repeat three times (No consumption mode)
5: Repeat three times (Toner is supplied only when the toner density is too low, and toner is
consumed only when the toner density is too dark.)
6 to 9: Disabled
Repeat: Interrupt
007
Specifies the maximum number of repeats of the toner density adjustment during printing.
DFU
Toner Supply Coefficient
008
Adjusts the time for the toner supply mode when a toner density is detected to be low.
*ENG [0 to 9 / 0 / 1 time/step]
*ENG [0 to 9 / 3 / 1 time/step]
*ENG [0 to 9 / 0 / 1 time/step]
*ENG [0 to 9 / 4 / 1 time/step]
*ENG [0 to 9 / 0 / 1 time/step]
*ENG [0 to 25.5 / 10 / 0.1 sec/step]
Main SP Tables-3
505