Ricoh D143 Field Service Manual page 55

If this setting is disabled (not selected), tell the customer this setting must be enabled (selected) before
you do the installation procedure.
• Installation Procedure
1. Connect the network cable if it needs to be connected.
2. Turn on the main power switch.
3. Go into the SP mode and push "EXECUTE" with SP5-878-001.
4. Exit the SP mode and turn off the operation switch. Then turn off the main power switch.
5. Turn on the machine power.
6. Do SP5-990-005 (SP print mode Diagnostic Report).
7. Go into the User Tools mode, and select [System Settings]
Erase Memory Setting]
8. Exit the User Tools mode.
9. Check the display and make sure that the overwrite erase icon [1] shows.
10. Check the overwrite erase icon.
The icon [2] is lit when there is temporary data to be overwritten, and blinks during overwriting.
The icon [3] is lit when there is no temporary data to be overwritten.
HDD Encryption
[On].
This icon is lit when there is temporary data to be overwritten,
Dirty
and blinks during overwriting.
This icon is lit when there is no temporary data to be
Clear
overwritten.
Copier Installation
[Administrator Tools] [Auto
53