Ricoh D143 Field Service Manual page 500

5. System Maintenance
[Acs Setting (FC to Bk)]
Adjusts the threshold for moving away the image transfer belt from the color PCDUs. This
SP moves the image transfer belt away from the color PCDUs when the number of B/W
2907
image printouts reaches the number of sheets specified with this SP after consecutive full
color image printouts in the full color mode.
If this SP is set to "0", the image transfer belt does not move away.
001 Continuous Bk Pages
2920 [Trans Mot Control]
0: Encorder 1 :FG
001
Selects the speed control mode for the ITB.
If SC443 occurs and machine does not recover, change this setting to "1".
SC443-00 Count
002
Displays the number of the ITB encodre error. SC443 is displayed if this counter counts to
"3".
[SecondaryFB: Threshold] Paper Transfer Roller Feed-back: Threshold Adjustment
2930
Adjusts the threshold between high resistance (division 1) and low resistance (division 2)
at the paper transfer roller. This SP affects SP2931 to SP2939.
001 Voltage
2960 [Process Interval]
Additional Time
001
Adjusts the additional time for ending the machine's process.
2970 [Cleaning After JOB]
No Refresh
001
Specifies the threshold sheets for the cleaning of the paper transfer roller without the
refresh mode.
498
*ENG [0 to 10 / 0 / 1 sheet/step]
*ENG [0 or 1 / 0 / 1 /step]
*ENG [0 to 3 / 0 / 1 /step]
*ENG [0 to 7000 / 6000 / 10 –V/step]
*ENG [0 to 10 / 0 / 1 sec/step]
[0 to 100 / 33 / 1 /step]
*ENG
0: No cleaning