Ricoh D143 Field Service Manual page 113

8. Attach the slide drive unit [A] to the finisher and connect it to the punch unit (
in the slide drive unit at
9. Make sure that the punch unit moves freely and is not blocked by the screws.
10. Put the side-to-side detection unit [A] in the machine. Make sure that the two pins are engaged
correctly at the front.
11. Make sure that the side-to-side detection unit moves smoothly on its rails. If it does not, make sure
that the rails are aligned with their grooves.
12. Attach the side-to-side detection unit and connect it at the rear (
13. Pull the short connector out of the connector [B] then connect the cable of the finisher (
• This is the 3-pin connector.
when you attach the screw
Punch Unit Type 3030 (D570)
x 2,
.
x 2, x 1,
x 1). Push
x 1).
x 1).
111