8. Connect the harness [I] to the connector [J] of the tray heater.
9. Route the harness [I] as shown and clamp it with four clamps (
10. Connect the harness [I] to the connector [K] of the mainframe.
11. Reassemble the mainframe and optional paper feed unit.
For Installing the Tray Heater in D538
1. Remove the rear cover of the mainframe (
2. Pull out the LCT drawer.
• If the right tray comes out with the left tray, push the right tray into the LCT.
3. Left tray [A] (
x 2)
x 4).
step 1 in "For Installing the Tray Heater in D537").
Anti-Condensation Heater Type A
133