Configuring A Wireless Connection Using Dhcp - Cisco Interactive Experience Client 4600 Series User Manual

Network Settings
Enter the subnet mask in the Subnet Mask field.
Step 6
Enter the gateway address in the Gateway field.
Step 7
Enter the primary DNS server's IP address in the Primary DNS server IP Address field.
Step 8
If there is a second DNS server, enter the secondary DNS server's IP address in the Secondary DNS
Step 9
server IP Address field.
When you complete the selections in this window, click Apply.
Step 10
To exit the Network window, click Close.
Step 11
In the System Settings window, click Reboot.
Step 12
Figure 3-6
If you change the network connection, the Cisco IEC 4600 Series device's IP address will change. Be
sure to record the new IP address.

Configuring a Wireless Connection using DHCP

If you want to configure a wireless connection to your network using DHCP, follow these steps:
Step 1 Press Ctrl-Alt-S to display the System Settings window.
Step 2 Click the Network icon.
Cisco Interactive Experience Client 4600 Series User Guide
3-6
Reboot Icon in the System Settings Window
Chapter 3 Configuring Settings