Connecting To The Network; Configuring An Ethernet (Wired) Connection - Cisco Interactive Experience Client 4600 Series User Manual

Chapter 2 Setting Up the IEC

Connecting to the Network

The Cisco IEC 4600 Series can be connected to the network using an Ethernet (wired) or wireless
connection. Either can be configured using DHCP or entering an IP address.
By default, the IEC 4600 Series is configured to look for a DHCP-enabled Ethernet network. If you are
connecting to another type of network (either static IP, Wireless, or both), you need to configure the
network using the Emergency Configuration Mode as described in "Using Emergency Configuration
Mode". Once in Emergency Configuration Mode, click the Network icon and then proceed to either
"Configuring an Ethernet Connection" or "Configuring a Wireless Connection".

Configuring an Ethernet (Wired) Connection

If you want to configure an Ethernet (wired) connection to the network using DHCP or a static IP
address, follow these steps:
Step 1 Press Ctrl-Alt-S to display the System Settings window.
Step 2 Click the Network icon.
Figure 2-10
If Ethernet is not the current interface, click the Ethernet radio button.
Step 3
Step 4 Choose to use DHCP or a static IP address:
To use DHCP, check the Use DHCP check box.
Network Icon in System Settings Window
Cisco Interactive Experience Client 4600 Series User Guide
Connecting to the Network
2-21