Cisco Interactive Experience Client 4600 Series User Manual page 122

Debugging Console
Command
help
exit
quit
sn
dmc
reboot
reset
Upgrade Commands
Enter the following commands to upgrade the firmware of the device.
Command
version
usys <url> Upgrade system firmware from URL
uapps
<url>
uloaders
The angle brackets (<>) indicates a required value. The square brackets ([]) indicate an optional value.
Note
To upgrade the firmware:
1.
2.
3.
Debugging Commands
Enter the following commands to debug the device and view system statistics.
Warning Only run the debug command when troubleshooting the IEC. By default, debugging is turned off. When
the debug command is turned on, every event is collected and sent to the IEM's Events tab. The act of
collecting and sending the events will use processing power and may impact the performance of the
IEC. When you are not troubleshooting an issue on the IEC, make sure that debugging has been turned
off by running the release command.
Cisco Interactive Experience Client 4600 Series User Guide
6-4
Table 6-1
Description
Show the help screen containing the list of commands
Quit the shell
Show device's serial number
Show the Device Maintenance Code (DMS)
Reboot the device (note that no confirmation to reboot will be asked)
Reset the device to factory default settings and reboot (note that no confirmation will
be asked)
Table 6-2
Description
Show firmware version
Upgrade applications firmware from URL
Upgrade loaders
Enter the usys <url> command where the URL is the location of the system firmware file.
Enter the uapps <url> command where the URL is the location of the applications firmware file.
Enter the uloaders command to switch to the new partition.
General Commands
Upgrade Commands
Chapter 6 Debugging Console