Cisco Interactive Experience Client 4600 Series User Manual page 124

Debugging Console
Figure 6-6
Management Commands
Enter the following commands to manage the device.
These management commands were not designed to configure the device but to aid troubleshooting.
Note
Command
mng
setmng <url>
compression <on|off>
dload
diload
dsave
disave
esave
dsync
pingmng
ping <host>
ismanaged
isreg
reg <account> <user>
[password]
ureg <user> [password]
The angle brackets (<>) indicates a required value. The square brackets ([]) indicate an optional value.
Note
Cisco Interactive Experience Client 4600 Series User Guide
6-6
lsusb Command Output
Table 6-4 Management Commands
Description
Show IEM's URL
Set IEM's URL (note that the prefix will be ignored; it always
should be 'https')
Turn management protocol compression on or off
Load device's profile from the IEM
Load device's information (name and description) from the
IEM
Save device's entire profile on the IEM
Save device's information (name and description) on the IEM
Save events on the IEM (note that the saved events will be
removed from the local event database)
Save unsaved properties from the device's profile on the IEM
Update device's status on the IEM
Ping the specified host
Check if the device is in managed mode
Check if the device is registered in the IEM
Register device in the IEM
Unregister device in the IEM
Chapter 6 Debugging Console