Advertisement

Cisco Edge 340 Series Installation Guide
OL-29523-01

About this Guide

This guide describes how to install the Cisco Edge 340 Series device and describes the LEDs and ports.
For configuration information, see the Cisco Edge 340 Series documentation on Cisco.com. For system
requirements, important notes, limitations, open and resolved bugs, and documentation updates, see the
release notes on Cisco.com.
Cisco Systems, Inc.
www.cisco.com

Advertisement

Table of Contents
loading

Summary of Contents for Cisco Edge 340 Series

  • Page 1: Table Of Contents

    • About this Guide This guide describes how to install the Cisco Edge 340 Series device and describes the LEDs and ports. For configuration information, see the Cisco Edge 340 Series documentation on Cisco.com. For system requirements, important notes, limitations, open and resolved bugs, and documentation updates, see the release notes on Cisco.com.
  • Page 2: Cisco Edge 340 Series Accessories

    Cisco Edge 340 Series Accessories Cisco Edge 340 Series Accessories The following list shows the accessories that you can purchase for the Cisco Edge 340 Series device: Power adapter • Power cord • Power cord retainer • WiFi external antenna •...
  • Page 3 Overview of the Cisco Edge 340 Series Figure 1 Cisco Edge 340 Series—Front panel Wireless SKU Cisco Edge 340 Series Non-wireless SKU Cisco Edge 340 Series SD card slot Bluetooth status USB ports Storage status Factory mode pinhole Wifi status...
  • Page 4 5W power to a connected device. Each of the other three USB ports can provide up to 2.5W power. When the Cisco Edge 340 is powered by PoE or PoE+ switch, only the two USB ports on the front panel are enabled, and each can provide up to 2.5W power.
  • Page 5: Power Management

    Wake on LAN The Cisco Edge 340 Series supports Wake on LAN when it is in the sleep mode or the soft off mode. The system can be woken up via an Ethernet message, and changed to the full on mode.
  • Page 6 Overview of the Cisco Edge 340 Series LEDs Figure 3 shows the LEDs on the front panel of the Cisco Edge 340 Series. Figure 3 Cisco Edge 340 Series LEDs on the Front Panel Cisco Edge 340 Series Bluetooth WiFi...
  • Page 7: Installing The Cisco Edge 340 Series

    Installing the Cisco Edge 340 Series You can install the Cisco Edge 340 Series on a wall or a pillar, a metal pole, or a ceiling T-joint by using the wall-mount kit. You can also install the Cisco Edge 340 Series on almost any Video Electronics Standards Association (VESA)-compliant flat-panel display that is attached to a third-party VESA bracket.
  • Page 8 Installing the Cisco Edge 340 Series Humidity around the Cisco Edge 340 does not exceed 85 percent. • Altitude at the installation site is below 2000m. • Warning Statements IMPORTANT SAFETY INSTRUCTIONS Warning This warning symbol means danger. You are in a situation that could cause bodily injury. Before you work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar with standard practices for preventing accidents.
  • Page 9 Warning 3 inches (7.6 cm) Statement 1076 Be aware of the size and weight of the Cisco Edge 340 Series when mounting. Ensure that the mounting Caution location has a stable flat surface and can safely support the weight of the Cisco Edge 340 Series.
  • Page 10: Powering On The Cisco Edge 340 Series

    Powering On the Cisco Edge 340 Series Installing the Cisco Edge 340 Series on a Desk or Table You can use your desktop-mounting kit to install a Cisco Edge 340 on a desk or table vertically by using the desktop-mount bracket.
  • Page 11: Regulatory Standards Compliance

    Regulatory Standards Compliance Regulatory Standards Compliance This section includes all the regulatory, safety, and EMC standards. Table 4 Regulatory Standards Compliance for the Cisco Edge 340 Series Specification Description Safety UL 60950-1 Second Edition CAN/CSA-C22.2 No. 60950-1 Second Edition EN 60950-1 Second Edition...
  • Page 12: Emc Class B Notices, Warnings, And Safety Information

    EMC Class B Notices, Warnings, and Safety Information EMC Class B Notices, Warnings, and Safety Information This section includes the EMC Class B warnings for the Cisco Edge 340 Series. Statement 2018—Class B Notice for FCC Modifying the equipment without Cisco’s authorization may result in the equipment no longer complying with FCC requirements for Class B digital devices.
  • Page 13 This is a Class B product based on the standard of the VCCI Council. If this is used near a radio or television receiver in a domestic environment, it may cause radio Interference. Install and use the equipment according to the instruction manual. VCCI-B Cisco Edge 340 Series Installation Guide OL-29523-01...
  • Page 14: Japanese Electric Appliance And Radio Laws

    Electrical Appliance and Material Safety Law prohibits the use of UL-certified cables (that have the “UL” or “CSA” shown on the cord), not regulated with the subject law by showing “PSE” on the cord, for any other electrical devices than products designated by CISCO. Canadian Compliance for the Cisco Edge 340 Series This device complies with Industry Canada licence-exempt RSS standard(s).
  • Page 15 Canadian Compliance for the Cisco Edge 340 Series Le présent émetteur radio with model: CS-E340W a été approuvé par Industrie Canada pour fonctionner avec les types d'antenne énumérés ci-dessous et ayant un gain admissible maximal et l'impédance requise pour chaque type d'antenne. Les types d'antenne non inclus dans cette liste, ou dont le gain est supérieur au gain maximal indiqué, sont strictement interdits pour l'exploitation de l'émetteur.
  • Page 16: Compliance Statement For Taiwan

    End-users and installers must be provide with antenna installation instructions and consider removing the no-collocation statement. Cisco Edge 340 Series Installation Guide OL-29523-01...
  • Page 17: Declaration Of Conformity For Rf Exposure

    This Device Meets International Guidelines for Exposure to Radio Waves The Cisco Edge 340 series device includes a radio transmitter and receiver. It is designed not to exceed the limits for exposure to radio waves (radio frequency electromagnetic fields) recommended by international guidelines.
  • Page 18 This Device Meets the Industry Canada Guidelines for Exposure to Radio Waves The Cisco Edge 340 series device includes a radio transmitter and receiver. It is designed not to exceed the limits for exposure to radio waves (radio frequency electromagnetic fields) as referenced in Health Canada Safety Code 6.
  • Page 19: Obtaining Documentation And Submitting A Service Request

    RSS feeds are a free service. Cisco and the Cisco logo are trademarks or registered trademarks of Cisco and/or its affiliates in the U.S. and other countries. To view a list of Cisco trademarks, go to this URL: www.cisco.com/go/trademarks. Third-party trademarks mentioned are the property of their respective owners. The use of the word partner does not imply a partnership relationship between Cisco and any other company.
  • Page 20 Obtaining Documentation and Submitting a Service Request Cisco Edge 340 Series Installation Guide OL-29523-01...

Table of Contents