Registering The Iec - Cisco Interactive Experience Client 4600 Series User Manual

Registering the IEC

Turn on the power to the video display.
Step 8
Connect an Ethernet cable to the LAN port on the Cisco IEC 4600 Series. Connect the other end of the
Step 9
Ethernet cable to an Ethernet wall jack or Ethernet port on a router or switch.
Connect the power adapter to the DC 12V in connector on the Cisco IEC 4600 Series.
Step 10
Plug the power adapter into an electrical outlet.
Step 11
The Cisco IEC 4600 Series will initialize now. When it finishes initializing, the COBRA screen appears.
Figure 2-3
After initialization "Startup URL is not configured" will appear at the top of the screen. It is referring to
Note
the URL that the Cisco IEC 4600 Series will use to display content once it is configured.
Record the serial number and IP address shown on the COBRA screen.
If there are any problems with the initial configuration or the network, the system will not initialize and
Note
the Cobra screen will not appear. If that happens, refer to "Using Emergency Configuration Mode".
Registering the IEC
The IEC 4600 Series must first be registered in the IEM to manage it remotely. To register a device, you
will need the following:
•
Cisco Interactive Experience Client 4600 Series User Guide
2-16
Initialization Screen
Enough licenses in the IEM to cover the new device
Chapter 2 Setting Up the IEC