Infrared Sensor - Cisco Interactive Experience Client 4600 Series User Manual

Hide thumbs Also See for Interactive Experience Client 4600 Series:
Table of Contents

Advertisement

Appendix E
Infrared Remote Controls
The Cisco remote control is battery-powered. It uses a standard, 3V CR2025 lithium battery,
manufactured by a well-known supplier such as Panasonic or Toshiba. The name of the actual
manufacturer is etched into the face of the battery.
When the battery loses its charge or when you remove the battery, the remote control will not work until
the battery is replaced.
You should always recycle or dispose of the battery in accordance with:
Remote control settings are not lost when you remove or replace the battery.
Note
To replace the battery in the remote control, follow these steps:
Step 1
Place the remote control on a flat surface, button-side down.
To unlock the battery clip and remove it, pinch the locking mechanism and slide the clip out of the remote
Step 2
control.
Step 3
To remove the old battery from the clip, pivot the battery so that it touches only the opening of the clip.
Insert a new battery so that positive charge (+) symbols are visible simultaneously on the battery and the
Step 4
clip.
Step 5
Slide the clip back in to the remote control.

Infrared Sensor

The IEC is equipped with an infrared (IR) sensor that receives, recognizes, and reacts to the signals from
this Cisco remote control.
The way that you mount an IEC can limit how well it responds to these signals. The mounting method
might block the IR sensor.
It is recommended to use an IR extender with the remote control. With the IR extender, the range of the
remote control is approximately up to 15 feet (4.57m).
Advarsel
Det brukes litiumbatterier i denne modulen. Forsøk ikke å lade, utlade eller
skifte ut disse batteriene.
Aviso
Este módulo utiliza baterias de Lítio. Não tente recarregar, descarregar ou
substituir essas baterias.
Advertencia!
Este módulo funciona con pilas de litio. No intente cargarlas, descargarlas ni
recambiarlas.
Varning!
Litiumbatterier används i denna modul. Försök inte att ladda upp, ladda ur
eller byta ut dessa batterier.
Its manufacturer guidelines.
Regulations in your locale for disposal and recycling.
Cisco Interactive Experience Client 4600 Series User Guide
Cisco Remote Control IEP-IR-K9
E-3

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Iec 4632Iec 4610

Table of Contents