Network Settings; Configuring An Ethernet Connection Using Dhcp - Cisco Interactive Experience Client 4600 Series User Manual

Network Settings

Network Settings
The Cisco IEC 4600 Series can be connected to the network using an Ethernet (wired) or wireless
connection. Either can be configured using DHCP or an IP address.

Configuring an Ethernet Connection using DHCP

If you want to configure an Ethernet (wired) connection to your network using DHCP, follow these steps:
Press Ctrl-Alt-S to display the System Settings window.
Step 1
Click the Network icon.
Step 2
Figure 3-1
If Ethernet is not the current interface, click on the Ethernet radio button.
Step 3
If the DHCP check box is not checked, check the Use DHCP check box.
Step 4
Cisco Interactive Experience Client 4600 Series User Guide
3-2
Network Icon in System Settings Window
Chapter 3 Configuring Settings