Configure A Wireless Network Connection - Cisco DMS-DMP-4300G User Manual

Chapter 11 Configure Network Settings

Configure a Wireless Network Connection

Timesaver Complete this optional procedure at your discretion.
Before You Begin
•
•
•
•
•
•
•
OL-15764-03
Do the hardware and firmware for your DMP support wireless networking? DMP 4305G and
DMP 4310G endpoints do not.
– To verify whether you must use an Ethernet cable, see
– Alternatively, if Table 2-2 on page 2-5
http://cisco.com/go/dms/dmp/datasheets.
The Broadcast SSID setting must be enabled on your wireless access points (also known as wireless
routers or WLAN controllers). Otherwise, your DMPs cannot connect to your WLAN and are
prevented from obtaining IP addresses.
We do not support "open" wireless networks. They are a security risk.
Does a security policy in your network restrict DHCP address assignments to known MAC
addresses? If so, locate the WLAN address printed on a sticker that is affixed to your DMP. Then,
share this address with your security policy administrator.
Verify that your wireless network is working correctly, is available, and you understand how it
authenticates connection requests.
Connect Over Ethernet.
Log in.
Table 2-2 on page
does not describe your DMP model, see its datasheet at
User Guide for Cisco Digital Media Player Device Manager 5.2.x
Procedures
2-5.
11-11