Iec Preparation - Cisco Interactive Experience Client 4600 Series User Manual

Appendix F Video Conferencing Using the Session Initiation Protocol Client
Figure F-2
The resolution of the video call from a Cisco video IP phone is fixed. It cannot be adjusted.
Note

IEC Preparation

The following steps must be done before setting up the SIP client.
Make sure that the IEC is installed, registered, configured, and up and running. Confirm that the startup
Step 1
URL is displaying.
Connect a webcam using a USB cable to a USB port on the IEC.
Step 2
Connect a microphone to the IEC. You can connect the microphone to either a USB port or the MIC-in
Step 3
port (shown on the figure below as the pink port with the microphone icon).
Sample Result - Call State on Kiosk
Cisco Interactive Experience Client 4600 Series User Guide
IEC Preparation
F-13