Cisco Interactive Experience Client 4600 Series User Manual page 224

Cisco IEC Set Up on the CUCM
Choose the Administrator Settings icon, which is button #4 on the Applications screen.
Step 2
Tip
Figure F-22
Choose the Network Setup icon, which is button #1 on the Administrator Settings screen.
Step 3
Step 4 Choose the Ethernet Setup icon, which is button #1 on the Network Setup screen.
Step 5 Choose the MAC Address icon, which is button #2 on the Ethernet Setup screen.
Cisco IEC Set Up on the CUCM
The Cisco IEC 4600 Series device set up on the CUCM is very similar to the Cisco IP Phone 9951 set
up on the CUCM except for a few options. An additional step is also required. This step is the setting up
of a User Profile. The User Profile is then linked to the Cisco IEC 4600 Series device after it is set up
on the CUCM.
Enter the IP address of your CUCM in your browser.
Step 1
Press the Enter button.
Step 2
In the CUCM main page, select Cisco Unified Communications Manager.
Step 3
Cisco Interactive Experience Client 4600 Series User Guide
F-26
You can either use the touch screen on the display or the numbers on the keypad to navigate the
phone settings.
Cisco Unified IP Phone 9951 Applications Screen
Appendix F Video Conferencing Using the Session Initiation Protocol Client