Cisco Interactive Experience Client 4600 Series User Manual page 236

Configuring Call Manager Information
Configuring Call Manager Information
Once the end points (the video IP phone and an IEC) have been registered on the CUCM, you have
several options for configuring the call manager information so that the IEC can call or receive calls from
the video IP phone:
•
•
Using a Policy on the IEM
The following steps explain how to enter the call manager information into the IEC's policy on the IEM.
Log in to the Cisco IEM which has the SIP policy enabled on it.
Step 1
Go to the policy that is applied to the Cisco IEC4610 or 4632 device.
Step 2
Click the Policy tab.
Step 3
Expand the application property.
Step 4
Step 5 In the data property, click the value field.
Figure F-43
Step 6 In the Application data editor, click +.
Cisco Interactive Experience Client 4600 Series User Guide
F-38
You can enter the call manager information in a policy on the IEM.
You can hard code the call manager information in the sipphone widget.
Value Field of the Data Property
Appendix F Video Conferencing Using the Session Initiation Protocol Client