Connecting To The Cisco Iem; Applying A Policy - Cisco Interactive Experience Client 4600 Series User Manual

Chapter 2 Setting Up the IEC
Figure 2-24
If you change the network connection, the Cisco IEC 4600 Series device's IP address will change. Be
sure to record the new IP address.

Connecting to the Cisco IEM

This section assumes that either you or an administrator at your company has already installed and
configured the Cisco IEM. If not, use the Cisco Interactive Experience Manager Installation Guide and
Cisco Interactive Experience Manager Administrator Guide to install and configure the Cisco IEM.

Applying a Policy

The startup URL is the content that will be displayed on the kiosk. Follow these steps to apply a policy
on the device so that the startup URL appears on the kiosk display.
Open a browser on your computer.
Step 1
Enter the Cisco IEM URL.
Step 2
Reboot Icon in the System Settings Window
Cisco Interactive Experience Client 4600 Series User Guide
Connecting to the Cisco IEM
2-33