Rf Exposure - Cisco Interactive Experience Client 4600 Series User Manual

Connecting the Hardware
Equipment must be installed and operated using the relevant manuals and only installed with the correct
Note
cables and connectors. Cisco Systems Inc. is not responsible for any radio or television interference
caused by unauthorized changes or modifications to this equipment. Unauthorized changes or
modifications could void the user's authority to operate the equipment.
This device complies with Part15 of the FCC rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Responsible party:
Cisco Systems Inc.
170 West Tasman Drive
San Jose, CA 95134
USA
+408 526-7208

RF Exposure

The Cisco products are designed to comply with the following national and international standards on
Human Exposure to Radio Frequencies.
•
•
•
•
•
To ensure compliance with various national and international Electromagnetic Field (EMF) standards,
Caution
the system should only be operated with Cisco approved antennas and accessories.
THIS DEVICE MEETS THE FCC GUIDELINES FOR EXPOSURE TO RADIO WAVES
Your device includes a radio transmitter and receiver. It is designed not to exceed the limits for exposure
to radio waves (radio frequency electromagnetic fields) as referenced in FCC Part 1.1310. The guidelines
are based on IEEE ANSI C 95.1 (92) and include a substantial safety margin designed to assure the safety
of all persons, regardless of age and health.
As such the systems are designed to be operated as to avoid contact with the antennas by the end user.
It is recommended to set the system in a location where the antennas can remain at least a minimum
distance as specified from the user in accordance to the regulatory guidelines which are designed to
reduce the overall exposure of the user or operator.
The device has been tested and found compliant with the applicable regulations as part of the radio
certification process.
Cisco Interactive Experience Client 4600 Series User Guide
2-12
US 47 Code of Federal Regulations Part 2 Subpart J
American National Standards Institute (ANSI) / Institute of Electrical and Electronic Engineers /
IEEE C 95.1 (99)
International Commission on Non Ionizing Radiation Protection (ICNIRP) 98
Ministry of Health (Canada) Safety Code 6. Limits on Human Exposure to Radio Frequency Fields
in the range from 3kHz to 300 GHz
Australia Radiation Protection Standard
Chapter 2 Setting Up the IEC