Using A Vnc Viewer - Cisco Interactive Experience Client 4600 Series User Manual

Using a VNC Viewer

Using a VNC Viewer
The IEC can be accessed by a VNC viewer. VNC is enabled or disabled in the IEM. The instructions
below explain how to create a custom action for VNC, set the remoteview.enabled property in the IEM
to 'true', and then launch the VNC viewer.
You will need the following:
1.
2.
Figure 2-39
To use a VNC viewer to access an IEC, follow these steps:
Step 1 Log into the IEM.
Step 2 Click Policies in the left pane.
In the Edit menu, click New Policy.
Step 3
Enter a policy name in the Policy Name field that indicates the purpose of this policy such as
Step 4
"VNC_Start" or "VNC_Viewer".
Step 5 Check the Is action check box to make this policy runtime.
Check the Add to custom actions checkbox to create a custom action.
Step 6
Cisco Interactive Experience Client 4600 Series User Guide
2-42
The IEC's Maintenance Code, which can be found in the General Tab of the device (see figure
below)
A VNC viewer
Maintenance Code in General Tab of Device
Chapter 2 Setting Up the IEC