Checking The Connection Status Between The Host And The Eternus Dx/Af - Fujitsu ETERNUS DX60 S3 User Manual

Appendix C Setting Procedures for Replacing HBAs
C.3 Checking the Connection Status Between the Host and the ETERNUS DX/AF
C.3 Checking the Connection Status Between the Host and the
ETERNUS DX/AF
Perform the following procedure to check the connection status between the host and the ETERNUS DX/AF.
Procedure
1
Click [Connectivity] in the navigation.
2
Click [FC/FCoE] in the category.
 The [FC/FCoE Host] screen appears.
3
Check the connection status between the relevant host and the ETERNUS DX/AF in the
"Status" field.
■ When the host affinity settings are used
 "Active" is displayed as the status. Proceed to
Replacement (When Host Affinity Settings are Used)" (page 418)
■ When the host affinity settings are not used (conventional LUN mapping is used)
 "Inactive" is displayed as the status. In this case, settings after replacing the HBA are not required.
The replacement of the HBA is complete.
417
ETERNUS Web GUI User's Guide (Operation)
Copyright 2016 FUJITSU LIMITED
"C.4 Required Storage System Settings After HBA
End of procedure
P2X0-1260-19ENZ0