Fujitsu ETERNUS DX60 S3 User Manual page 64

Chapter 2 System Status
2.10 Storage Migration
• The path groups must be deleted after the data migration is complete. The following operations are not
available before path groups are deleted:
- Hot controller firmware upgrade is being performed in the destination storage system
- Eco-mode schedule setting of the RAID group to which the destination volume belongs
- Eco-mode schedule setting of the Thin Provisioning Pool (TPP) to which the destination volume
belongs
- Capacity expansion of the RAID group to which the destination volume belongs
- RAID migration of the destination volume
- Encryption of the destination volume
- Capacity expansion of the destination volume
- Deletion of the destination volume
- Port mode modification of the destination FC-Initiator port
- Port parameter setting of the destination FC-Initiator port
- Reduction of the CA to which the destination FC-Initiator port belongs
• To start Storage Migration, refer to "Start Storage Migration" in "ETERNUS Web GUI User's Guide
(Settings)".
• A started Storage Migration can be suspended, stopped, and restarted in volume units on the [Path Group
Detail Information] screen. Refer to "Suspend Storage Migration", "Stop Storage Migration", or "Restart
Storage Migration" in "ETERNUS Web GUI User's Guide (Settings)" for details.
The following items are displayed in the Main area:
• Path Group
The path group number is displayed. Click this item to display the [Path Group Detail Information] screen.
Refer to "2.10.1 Path Group Detail Information" (page 65)
A path group combines the paths for data migration into a group for each source storage system. The paths
from a single source storage system to the local (destination) storage system constitute a path group.
• Vendor ID
The manufacturer name of the source storage system to which the path is created is displayed.
An inconvertible code is displayed as "*".
64
ETERNUS Web GUI User's Guide (Operation)
Copyright 2016 FUJITSU LIMITED
for details.
P2X0-1260-19ENZ0