Appendix C Setting Procedures For Replacing Hbas; Advance Preparation; C.1 Advance Preparation - Fujitsu ETERNUS DX60 S3 User Manual

Appendix C
Setting Procedures for Replacing HBAs
This appendix describes how to replace a Host Bus Adapter (HBA) in the ETERNUS DX.
When management software such as ETERNUS SF Storage Cruiser is used, use the management software for
migrating the current access path settings instead of the procedure that is provided in this manual.
One of the following connection statuses is used between a host and an ETERNUS DX. Note that the required
procedures depend on the connection status.
• When the host affinity settings are used
• When the host affinity settings are not used (when conventional LUN mapping is used)
C.1

Advance Preparation

Before starting the operation, check the following information.
• The WWN of the current HBA
• The host name corresponds to the WWN of the current HBA
• The WWN of the new HBA
415
ETERNUS Web GUI User's Guide (Operation)
Copyright 2016 FUJITSU LIMITED P2X0-1260-19ENZ0