Fujitsu ETERNUS DX60 S3 User Manual page 166

Chapter 3 Component Status
3.19 Drive Detail
• Motor Status
The drive motor status is displayed.
- Active
The drive motors are activated.
- In the Boot Process
The drive motors are starting up.
- Idle
The drive motors are stopped.
- In the Stop Process
The drive motors are being stopped.
- Power off
The drive power is being turned off.
• Rebuild/Copyback Progress
When rebuild or copyback is being performed, the progress rate is displayed.
When rebuild or copyback is being performed, the progress rate is displayed.
• Patrol
- Total completed passes
The current total number of completed disk drive patrol cycles is displayed. "Completed passes"
indicates the number of times the disk patrol for all of the target drives is complete.
If the device configuration has been changed using the [Apply Configuration] function, the patrol
progress information (total completed passes, progress with current pass, and completed passes since
last power on) returns to the default settings.
- Progress with current pass
The progress rate of the currently running disk drive patrol process is displayed.
If the patrol is not operating for reasons such as a drive failure or a drive being formatted, a "-"
(hyphen) is displayed.
- Completed passes since last Power On
The current total number of completed disk drive patrol cycles since the last power on is displayed.
"Completed passes since last Power On" may be cleared when the Controller Firmware is applied, or
due to a CM failure.
• Vendor ID
The drive manufacturer name is displayed.
• Product ID
The drive manufacturer name is displayed.
• Serial Number
The serial number of the drive is displayed.
• WWN
The drive WWN is displayed.
• Firmware Version
The drive firmware version is displayed.
166
ETERNUS Web GUI User's Guide (Operation)
Copyright 2016 FUJITSU LIMITED P2X0-1260-19ENZ0