Chapter 2 System Status
2.1 System (Basic Information)
Whether the Virtual Volume function is enabled or disabled is displayed.
The Virtual Volume function cannot be set with Web GUI. To set the Virtual Volume function, use ETERNUS
SF Storage Cruiser.
For the ETERNUS DX60 S3, this item is not displayed.
The serial number of the ETERNUS DX/AF is displayed.
The WWN of the ETERNUS DX/AF is displayed.
The current controller firmware version is displayed.
VxxLyy-zzzz (Vxx: Version, Lyy: Level, zzzz: Release number)
General status (detail) of the ETERNUS DX/AF is displayed. Refer to
The current status and the factor of the cache are displayed. The normal status is "Write Back Mode".
"Cache Mode" (page 26)
Write Back Mode
Write Through (Pinned Data)
Write Through (Battery)
Write Through (Maintenance)
Write Through (1CM)
The Remote Support status (REMCS or AIS Connect) is displayed. If the Remote Support is not set, a "-"
(hyphen) is displayed.
The Remote Support is operating.
Maintenance in Progress
The ETERNUS DX/AF is under maintenance and the Remote Support is temporarily stopped.
After the maintenance is complete, Remote Support is automatically resumed.
The Remote Support is stopped.
The operation mode is displayed.
The ETERNUS DX/AF is in operation.
The ETERNUS DX/AF is under maintenance.
The CM to which ETERNUS Web GUI is connected is displayed.
ETERNUS Web GUI User's Guide (Operation)
Copyright 2016 FUJITSU LIMITED
"A.1 Storage System General Status"