Fujitsu ETERNUS DX60 S3 User Manual page 24

Chapter 1 Screen Operations
1.1 Overview
■ Auto Refresh
The [Overview] screen is refreshed at the specified update interval.
Select the update interval to refresh the [Overview] screen from "OFF", "60 sec.", "120 sec.", or "180 sec.". The
initial state is "OFF".
The monitoring time is reset to "0" when the update interval is changed or the [
specified interval is a value other than "OFF", the new update interval is applied after the monitoring time is
reset.
The update interval works while the user is logged in to ETERNUS Web GUI even when other functions are
started from the [Overview] screen. The update interval returns to the initial state ("OFF") when the Master
CM is switched or when the user logs out of ETERNUS Web GUI.
Auto refresh is available only for the [Overview] screen. Screens other than [Overview] are refreshed when
the [ ] icon is clicked or a screen is redisplayed.
■ System Messages
A system message is displayed.
• Message
When any information from the ETERNUS DX/AF exists, an information message is displayed.
• Message
When an event causes warning status, a warning message is displayed.
If a warning message is generated, the LCD message is displayed.
If an Advanced Copy path in warning status exists, a message is displayed.
• Message
When an event causes error status, an error message is displayed.
If an error message is generated, the LCD message is displayed.
If an Advanced Copy path in error status exists, a message is displayed.
An "LCD message" is a message to notify if a failure or warning status occurs. It is displayed when the
Master CM is used to operate the ETERNUS DX (or when a user logs in to the ETERNUS DX8700 S3/DX8900
S3 by specifying the Master IP address (*1) via a web browser).
*1: Refer to "Setup Network Environment" in "ETERNUS Web GUI User's Guide (Settings)" for details.
System Messages
24
ETERNUS Web GUI User's Guide (Operation)
Copyright 2016 FUJITSU LIMITED
] icon is clicked. If the
P2X0-1260-19ENZ0