Chapter 2 System Status
2.1 System (Basic Information)
System (Basic Information)
This function displays the system information and a list of users who are currently logged in.
If the message "Currently Network Configuration is set to factory default." is displayed in the system mes-
sage field, the network environment settings for the MNT port must be performed. Use the [Setup Net-
work Environment] function in the [Network] screen under the [System] navigation. Some functions are
not available if the network environment settings are incomplete.
If the message "Configuration was applied to storage system." is displayed in the system message field,
the ETERNUS DX/AF must be rebooted. Any setting processes cannot be performed until the applied
configuration information is enabled by rebooting the storage system.
The "Login User" list is displayed only when a user account with the "User Management" policy is used to
The following login users are displayed:
Users who are logged in to the Master CM from ETERNUS Web GUI
Users who are logged in to the Slave CM from ETERNUS Web GUI
Users who are logged in to the Master CM from ETERNUS CLI or other software
(Users who are logged in to the Slave CM from ETERNUS CLI or other software are not displayed.)
If the system message "Unified Storage license has been registered." is displayed, the unified upgrade
must be performed. Note that "Maintenance Operation" policy is required to perform the unified upgrade.
The storage system name is displayed at the top of the [System] navigation category.
The "Storage System Name" is specified using the [Modify Storage System Name] function. Refer to
"Modify Storage System Name" in "ETERNUS Web GUI User's Guide (Settings)"
Click the "Storage System Name" in the category again to display the latest information in the screen.
For the ETERNUS DX8700 S3/DX8900 S3
ETERNUS Web GUI User's Guide (Operation)
Copyright 2016 FUJITSU LIMITED