Network - Fujitsu ETERNUS DX60 S3 User Manual

Chapter 2 System Status

2.2 Network

2.2 Network
This function displays the network environment of each port in the ETERNUS DX/AF.
• If the message "Currently Network Configuration is set to factory default." is displayed in the system
message field, the network environment settings for the MNT port must be performed. Perform the
[Setup Network Environment] function in [Action]. Some functions are not available if the network
environment settings are incomplete. Refer to "Setup Network Environment" in "ETERNUS Web GUI User's
Guide (Settings)" for details.
• Click the [
to this screen, it takes approximately 10 seconds to update the display contents. Wait at least 10 seconds
and click the [
■
IPv4 Settings
The network setting information is displayed.
The Simple Network Management Protocol (SNMP) Information and the E-Mail Information are displayed
under the network setting information.
The following items are displayed in the Main area:
• Port
The port type is displayed.
- For the ETERNUS DX60 S3/DX100 S3/DX200 S3, the ETERNUS AF250, and the ETERNUS DX200F
MNT and RMT
- For the ETERNUS DX500 S3/DX600 S3, the ETERNUS DX8100 S3/DX8700 S3/DX8900 S3, and the
ETERNUS AF650
MNT, RMT, and FST
] icon to display the latest screen. Note that after changing the firewall setting and returning
] icon or click [Network] in the category to display the [Network] screen again.
ETERNUS Web GUI User's Guide (Operation)
Copyright 2016 FUJITSU LIMITED
41
P2X0-1260-19ENZ0