Fujitsu ETERNUS DX60 S3 User Manual page 264

Chapter 5 Connectivity Status
5.3 CA Port Group
The following items are displayed in the Main area:
• Port
The location information of the target port is displayed.
- CM#x CA#y Port#z (x: CM number, y: CA number, z: Port number)
• Type
The CA type (fixed at "SAS") of the target port is displayed.
• Status
The status of the target port is displayed.
• Transfer Rate
The transfer speed of the target port is displayed.
- Auto-negotiation
- 1.5 Gbit/s
- 3 Gbit/s
- 6 Gbit/s
• Reset Scope
The reset scope of the target port is displayed.
Reset scope is the range where the command reset request from the server is performed, when the target
port is connected to multiple servers.
- I_T_L (I: Initiator, T: Target, L: LUN)
Reset (cancel) the command request from the server that sent the command reset request.
- T_L (T: Target, L: LUN)
Reset (cancel) the command request from all of the servers that are connected to the port.
• Release Reservation if Chip is Reset
Whether the function to release the reservation status of the volume when the target port (chip) is reset is
enabled or disabled is displayed.
• Host Group
The name of the host group that has the host affinity setting with the target port is displayed.
If no host group with the host affinity setting exists, a "-" (hyphen) is displayed.
• Port Group
The name of the port group to which the target port belongs is displayed.
If the target port does not belong to a port group, a "-" (hyphen) is displayed.
• SAS Host Address
SAS host addresses of all SAS hosts that have the host affinity setting with the target port are displayed.
If the host affinity setting is not configured, a "-" (hyphen) is displayed.
264
ETERNUS Web GUI User's Guide (Operation)
Copyright 2016 FUJITSU LIMITED P2X0-1260-19ENZ0