Setting Up Rs-232C Communication - IDK MSD-6203 Command Reference Manual

2.1.3 Setting up RS-232C communication

(1) Connect the MSD and the control device via an RS-232C cable.
(2) Set the RS-232C communication as follows:
・RS-232C communication: Baud rate, data bit length, parity check, and stop bit
・Operation mode of RS-232C communication: "RECEIVER"
(3) For the control device, set the same values in the same way as RS-232C communication (baud rate, data
bit length, parity check, and stop bit) in step (2) above.
(4) Send a communication command from the control device to the MSD in order to check the control status of
the MSD.
Step (3)
Step (1)
RS-232C cable
Laptop
(Controller)
[Fig. 2.2] Setting RS-232C communication (Example: MSD-6208 with Dante)
■ Operation example of RS-232C communication
[Fig. 2.3] RS-232C communication (Example: MSD-6208 with Dante)
Step (4)
Communication
command
Communication
Command to MSD
RS-232C cable
Laptop
MSD-62 series Command Guide
【Reference: User's Guide】
RS232C cable
Output control
Command to external
device
Step (2)
Projector
7