IDK MSD-6203 Command Reference Manual page 49

@GIS / @SIS
Getting Command
Response
Setting Command
Response
Parameter
Getting Command
example Response
Description Getting the setting of Automatic measurement of the start position.
Setting Command
example Response
Description Setting signal that is currently input from IN8 to "1" (Current input signal is not
Remarks
@GSM / @SSM
Getting Command
Response
Setting Command
Response
Parameter
Getting Command
example Response
Description Getting the set automatic measurement mode when unregistered signal is input.
Setting Command
example Response
Description Setting the automatic measurement to be executed when unregistered signal is
Remarks
Automatic measurement of start position
@GIS
@GIS, mode_1, mode_2
@SIS, ch, mode
@SIS, ch, mode
mode_1-2 / mode: Automatic measurement
0 = All inputs from this input channel are not measured automatically.
1 = Current input signal is not measured automatically.
2 = Current input signal is measured automatically. [Default]
ch: Input channel
0 = All analog inputs, 7 = IN7, 8 = IN8
@GIS
@GIS,0,2
IN7: not measured automatically, IN8: measured automatically.
@SIS,8,1
@SIS,8,1
measured automatically).
These commands are only for analog input.
IN7 and IN8 are available only if "0" (Analog signal) is selected for "@GIN / @SIN
Signal selection of DVI input connector". If "1" (Digital signal) is selected, "-1" is
returned.
Automatic measurement when unregistered signal is input
@GSM
@GSM, mode
@SSM, mode
@SSM, mode
mode: Automatic measurement
0 = Not execute, 1 = Execute [Default]
@GSM
@GSM,1
Automatic measurement is set to "1" (Execute).
@SSM,1
@SSM,1
input.
－
MSD-62 series Command Guide
49