IDK MSD-6203 Command Reference Manual page 90

MSD-62 series Command Guide
@GEC / @SEC
Getting Command
Response
Setting Command
Response
Parameter
Getting Command
example Response
Description
Setting Command
example Response
Description
Remarks
90
Control command (contact closure)
@GEC, no
@GEC, no, delay, port, memo, ccno_1, cc_1, pulse_1 (, ccno_2, cc_2,
pulse_2･･･)
@SEC, no, delay, port, memo, ccno_1, cc_1, pulse_1 (, ccno_2, cc_2,
pulse_2･･･)
@SEC, no, delay, port, memo, ccno_1, cc_1, pulse_1 (, ccno_2, cc_2,
pulse_2･･･)
no: Control command number
1 to 32
delay: Delay time
0 = 0 sec. to 999999 = 999.999 sec.
port: Contact closure control
2048= For contact closure control
memo:
Up to 14 characters of 20 to 7D except 2C (,) from ASCII codes.
ccno_1-8: Contact closure number
ccno 1 2
CONTACT CLOSURE 1
Contact
CH1 CH2
closure
cc_1-8: Contact closure control
0 = OFF, 1 = ON, 2 = Toggle, 3 = Not control
pulse_1-8: pulse width
0 = Hold, 100 = 100 ms to 9990 = 9990 ms (by 10 ms)
Pulse width after the completion of contact closure.
Getting commands: only contact closure numbers to be controlled are replied.
Setting commands: specify only contact closure numbers to be controlled. For
contact closure numbers that do not specify parameter, "Not check" is set.
@GEC,7
@GEC,7,20,2048,SCREEN UP,1,1,100
Getting settings of control command 7.
・Delay time: 20ms
・Memo: SCREEN UP
・Contact closure1's CH1: ON for 100 ms
・Other outputs: not controlled.
@SEC,6,50,2048,PROJECTOR ON,1,0,200,2,1,0
@SEC,6,50,2048,PROJECTOR ON,1,0,200,2,1,0
Setting Control command number 6 as follows:
・Delay time: 50 ms
・Memo: PROJECTOR ON
・CH1 of contact closure1 : ON for 200 ms
・CH2 of contact closure : ON
・Other contact closure : Not controlled
－
3 4 5
CONTACT CLOSURE 2
CH3 CH1 CH2
6 7 8
CONTACT CLOSURE 3
CH3 CH1 CH2
9
CH3