Table of Contents
Advertisement
@GAT / @SAT
Getting
Command
Response
Setting
Command
Response
Parameter
Getting
Command
example
Response
Description Getting the set test tone output.
Setting
Command
example
Response
Description Setting OUT1 to output test tone (1k Hz) to all speakers.
Remarks
Test tone
@GAT
@GAT, tone_1, speaker_1, tone_2, speaker_2, tone_3, speaker_3, ･･･, tone_8,
speaker_8
@SAT, ch_1, tone_1, speaker_1 (, ch_2, tone_2, speaker_2･･･)
@SAT, ch_1, tone_1, speaker_1 (, ch_2, tone_2, speaker_2･･･)
tone_1-8: Test tone
0 = OFF [Default], 1 = 1 kHz, 2 = 400 Hz
speaker_1-8: Speaker
0 = ALL [Default],
2 = REAR L/R,
4 = FRONT LEFT,
6 = LOW FREQUENCY EFFECT,
8 = REAR LEFT,
10 = REAR LEFT CENTER,
ch_1-8: Output channel
0 = All outputs, 1 = OUT1 to 8 = OUT8
@GAT
@GAT,2,1,2,1,2,1,2,1,0,0,0,0,0,0,0,0
OUT1 to OUT4: Outputs test tone (400 Hz) to FRONT L/R.
OUT5 to OUT8: Not output test tone.
@SAT,1,1,0
@SAT,1,1,0
－
MSD-62 series Command Guide
1 = FRONT L/R,
3 = REAR L/R CENTER,
5 = FRONT RIGHT,
7 = FRONT CENTER,
9 = REAR RIGHT,
11 = REAR RIGHT CENTER
69
Advertisement
Table of Contents
