IDK MSD-6203 Command Reference Manual page 76

MSD-62 series Command Guide
@GSP / @SSP
Getting Command
example Response
Description
Setting Command
example Response
Description
Setting Command
example Response
Description
Remarks
@RME
Setting Command
Response
Parameter
Setting Command
example Response
Description
Setting Command
example Response
Description
Remarks
76
The number of speakers (cont'd)
@GSP,1
@GSP,1,6,0,1,2,3
Getting the IN1 speaker configuration.
Six speakers (Front Left / Right, Low Frequency Effect, Front Center, Rear Left /
Right) are used.
@SSP,2,8
@SSP,2,8
Setting IN2 speaker configuration to Front Left / Right, Low Frequency Effect,
Front Center, Rear Left / Right, Rear Left / Right Center (eight speakers).
Completed normally.
@SSP,3,8,0,3,5,6,7
@ERR,1
Setting IN3 speaker configuration to Front Left / Right, Rear Left / Right, Front
Left / Right Center, Rear Left / Right Center, Front Left / Right Wide.
The number of speakers is 10 which exceeds the settable value, and it causes
the error.
These commands are only for digital input.
IN6 and IN7 are available only when "1" (Digital signal) is selected for "@GIN /
@SIN Signal selection of DVI input connector". If "0" (Analog signal) is
selected, "-1" is returned.
Copying EDID
@RME, out, number, name
@RME, out, number, name
out: Connector to be loaded
1 = OUT1 to 8 = OUT8
number: Destination COPY DATA number
1 to 8
name: COPY DATA name
Up to 10 characters using 20 to 7D from ASCII codes.
You can skip this setting. In this case, only EDID settings are saved without
changing currently saved name.
@RME,1,1
@RME,1,1
Loading EDID data of the sink device connected to OUT1 and saving it in COPY
DATA 1.
@RME,3,4,800x600
@RME,3,4,800x600
Loading EDID data of the sink device connected to OUT3, naming it "800x600"
and saving it in COPY DATA 4.
@GED / @SED EDID