IDK MSD-6203 Command Reference Manual page 56

MSD-62 series Command Guide
@GVO / @SVO
Getting Command
Response
Setting Command
Response
Parameter
Getting Command
example Response
Description Getting the video output connectors.
Setting Command
example Response
Description Setting video output connector.
Remarks
56
HDMI / HDBaseT output
@GVO
@GVO, out_1A, out_1B, out_2A, out2B, ..., out_8A, out_8B
@SVO, ch_1, out_1A, out_1B (, ch_2, out_2A, out_2B･･･)
@SVO, ch_1, out_1A, out_1B (, ch_2, out_2A, out_2B･･･)
out_1A-8A: HDMI (OUT A) output video
out_1B-8B: HDBaseT (OUT B) output video
0 = Not output, 1 = Output
[Default]: HDMI output signal is output from HDMI output connector,
HDBaseT signal is not output from HDBaseT output connector
(All output channels)
* The MSD cannot output signals from HDMI connector and HDBaseT
connector simultaneously. Ensure to set only one connector to output
signal
ch_1-8: Output channel
0 = All outputs, 1 = OUT1 to 8 = OUT8
@GVO
@GVO,1,0,1,0,1,0,1,0,0,1,0,1,0,1,0,1
OUT1 to OUT4: The HDMI output connectors output video while
the HDBaseT output connectors do not output video.
OUT5 to OUT8: The HDMI output connectors do not output video while
the HDBaseT output connectors output video.
@SVO,1,1,0
@SVO,1,1,0
OUT1: The HDMI output connector outputs video and
the HDBaseT output connector does not output video.
An error occurs if the same parameter is issued to both HDMI output connector
and HDBaseT output connector.