Table of Contents
Advertisement
MSD-62 series Command Guide
@GCF / @SCF
Getting
Command
Response
Setting
Command
Response
Parameter
Getting
Command
example
Response
Description
Setting
Command
example
Response
Description
Remarks
78
RS-232C communication mode
@GCF
@GCF, mode_1, ..., mode_11
@SCF, port, mode
@SCF, port, mode
mode: Operation mode
mode_1: Operation mode of RS-232C connector
mode_2: Operation mode of HDBaseT input connector IN5
mode_3: Operation mode of HDBaseT input connector IN6
mode_4 to mode_11:Operation mode of HDBaseT output connector OUT1 to
OUT8
0 = RECEIVER mode [Default], 1 = TRANSMITTER mode
port: RS-232C channel
0 = All channels,
2 = IN5,
4 = OUT1,
6 = OUT3,
8 = OUT5,
10 = OUT7,
@GCF
@GCF,1,1,1,1,1,1,1,1,1,1,1
Getting the set operation mode
TRANSMITTER mode
@SCF,1,1
@SCF,1,1
Setting RS-232C connector to TRANSMITTER mode.
These commands are only for RS-232C.
If IP address or RS-232C communication setting is changed, the communication
may be disabled. Change the environmental settings based on the MSD settings.
1 = RS-232C connector,
3 = IN6,
5 = OUT2,
7 = OUT4,
9 = OUT6,
11 = OUT8
Advertisement
Table of Contents
