Input Timing - IDK MSD-6203 Command Reference Manual

3.3.8 Input timing

@AIS / @AIT
Setting Description
Command
Response
Setting Description
Command
Response
Parameter
Setting Command
example Response
Description
Setting Command
example Response
Description
Setting Command
example Response
Description
Remarks
Automatic measurement
Starting automatic measurement of the start position and display period.
@AIS, ch
@AIS, ch
Starting automatic measurement with a desired aspect ratio.
@AIT, ch (, mode)
@AIT, ch (, mode)
ch: Input channel
7 = IN7, 8 = IN8
mode: Measurement mode
-1 = NEXT ASPECT, 0 = 4:3, 1 = 5:4, 2 = 5:3, 3 = 16:9, 4 = 16:10
If you select "NEXT ASPECT", the next aspect ratio will be selected in order
every time the automatic measurement is executed. If you do not set any mode
parameter, "NEXT ASPECT" mode will be applied.
@AIS,8
@AIS,8
Starting the automatic measurement of IN8 the start position and display period.
@AIT,8,0
@AIT,8,0
Starting the automatic measurement of IN8 input timing setting at the aspect ratio
of "4:3".
@AIS,8
@ERR,7
If the automatic measurement fails, an error is returned.
These commands are valid only if analog RGB/analog YPbPr signal is input.
MSD-62 series Command Guide
45